InteliLite Global Guide
123
start Start the engine in MAN mode.
stop Stop the engine in MAN mode.
fault reset Acknowledging alarms and deactivating the horn output.
gcb close Closing GCB in MAN and TEST mode.
gcb open Opening GCB in MAN and TEST mode.
off Switching to OFF mode.
man Switching to MAN mode.
auto Switching to AUTO mode.
status Get status information from controller unit.
help Get a list of available SMS requests.
Note: Between commands are internal delays adjusted due to system requirements.
Example: When the controller, in AUTO mode, with a controller name of “InteliLite-Test”, with the CM-
GPRS module and access code “0” receives the SMS:
0 man, start, gcb close, gcb open, stop, auto
Controller mode will be changed to MANUAL mode. The engine will be started and GCB will close. Then
GCB will open, the engine will stop and it will go into AUTO mode again.
The controller will send back the SMS (controller will respond to SMS after every command has been
finished, not sooner.):
#InteliLite-Test: <OK>,<OK>,<OK>, <OK>,<OK>, <OK>
The value <OK> or <ERROR> means if the command has been performed succesfuly or not.
Emails
Event Email
The InteliLite controller equipped with the CM-Ethernet communication module is able to send Event Email
according to the setting of setpoint:
Event Message (page 329)
Note: Firstly setpoints Email Address 1 (page 326) and SMTP Sender Address (page 320) (for CM-GPRS) or
SMTP Sender Address (page 331) (for CM-Ethernet) have to be adjusted.
Note: Summer Time Mode (page 263) and Time Zone (page 328) have to be adjusted for correct time in emails.
Message structure:
Controller
-----------------------------------------------
Name: XXX
Serial number: XXX
SW branch: XXX
SW version: XXX
Application: XXX
Appl. version: XXX
Date: dd/mm/yyyy
Time: hh:mm:ss
To Next Page
Loading...
Need help?
General
