Operation Monitoring
43
C3M2-OM-EN-02
Section 4: Operation Monitoring
Measured values, indicators, warnings and messages related to
the operation of the truck and engine are displayed on a
multifunction display console (MDC). The MDC is mounted on
the control panel.
4.1 Daily Pre-Shift Inspection Screen
When the key switch is turned to position 1 (operating voltage) the MDC powers up
and displays the daily pre-shift inspection screen illustrated below.
This screen is displayed in order to ensure that the trucks operator remembers to
perform the pre-use checks before commencing operation of the truck. The pre-use
checks are described in section 5.1 Pre-Use Checks on page 57.
The screen above is displayed until button ‘D’ - on the MDC - is pressed to accept that
the message on the screen has been acknowledged.
After button ‘D’ has been pressed, the home screen, detailed on the following page is
displayed.
DAILY PRE-SHIFT INSPECTION
Are all safety and operational checks
performed
A
B
C
D
E F
G
o
To Next Page
Loading...
