Operation
77
C3M2-OM-EN-02
Caution
Do not move the four-way direction switch when the truck is moving.
Moving the four-way direction switch when the truck is moving may cause
the truck to change direction abruptly and carries a risk of personal injury
and machine damage.
After changing travel mode, confirm that the mode indicator on the dash
cluster is in agreement with the mode selected.
If the direction control does not respond or the correct mode indicator does
not illuminate park the truck in a safe location and inform the relevant
supervisor.
Warning
Only operate the truck from the operator’s seat with the seat belt buckled
and the cabin door closed and latched securely. Do not place any part of the
body outside the cabin while operating the truck. Do not carry passengers.
Remain in the seat with the seat belt fastened while the truck is moving. The
seatbelt will help you remain inside the cabin should the truck tip over.
Never jump from the truck if it begins to tip over. Keep all body parts inside
the cabin.
Failure to follow these guidelines can result in serious injury or death.
Note
Allow the engine to idle for 2-3 minutes before stopping it after a full load
operation.
5.10.2 LPG engine stopping procedure:
1. Ensure the park brake is applied and the four-way direction switch is in the
neutral position.
2. Lower the mast fully and tilt the mast forward fully.
3. Ensure the accelerator pedal is not being pressed.
4. Allow the engine to idle without load for 2-3 minutes.
5. Turn the ignition key switch anticlockwise to the ‘0’ position.
6. Close the valve on the LPG bottle/tank.
7. Remove the ignition key.
5.11 Moving Off
It is important to be aware of how the Combilift truck moves and how to drive it in a
safe and efficient manner. The Combilift can be driven forward, backward, left or right
by selecting the desired direction of travel with the four-way direction switch.
To Next Page
Loading...
