Operation
82
C3M2-OM-EN-02
Observe floor loading limits.
Check safe working load (SWL) of racking before placing a load onto it.
ALWAYS consult the capacity chart in the cabin of the truck before lifting a load
and never exceed the rated capacity and load centre of the truck.
When manoeuvring to pick up a load, avoid erratic movements that could result
in damage to the load and/or truck.
Use caution when handling long, high or deep loads.
If the load obstructs view, drive in reverse, left or right. Always look in the
direction of travel.
Make sure there is adequate clearance for the truck and load including overhead.
Do not allow anyone to stand beneath or pass under the mast or forks.
Never use the forklift to elevate anyone without the use of an approved man up
cage.
Be aware of rear end swing when turning.
Never carry passengers on the truck.
Obey site rules and take particular care when there are pedestrians who should
be given priority.
Use banks men if operating in congested or busy areas.
Operate controls smoothly.
Stop the truck, apply the park brake and select neutral before lifting a load.
Four-Way Drive Loading/Unloading Advantages
The four-way travel capability of the Combilift truck allows for much easier
alignment of the forks/load with the picking/placing area than with any other
conventional type of forklift truck such as a counterbalance, reach or side loader.
To position the forks/load precisely with the placing/picking location select the
required drive direction with the four-way direction switch.
Press the inch brake pedal down fully, look all around to make sure the way is
clear, then release the park brake.
Press the accelerator pedal to increase the engine speed then gradually release
the inch brake pedal until the truck starts to move slowly.
Make small steering corrections as necessary to align and position the forks/load
precisely.
When aligned centrally with, parallel to and the correct distance from the desired
location fully press the inch brake pedal to stop the truck.
Apply the park brake, move the direction control switch to the neutral position
then, release the inch brake pedal.
To Next Page
Loading...
