CommScope ERA UAP2 - Equipment Symbols Used; Compliance

5. Noce: For Class B signal boosters
WARNING. This is NOT a CONSUMER device. It is designed for installaon by FCC LICENSEES and
QUALIFIED INSTALLERS. You MUST have an FCC LICENSE or express consent of an FCC Licensee to
operate this device. You MUST register Class B signal boosters (as dened in 47 CFR 90.219) online at
hp://www.fcc.gov/signal-boosters/registraon. Unauthorized use may result in signicant forfeiture
penales, including penales in excess of $100,000 for each connuing violaon.
6. Noce: The unit complies with Overvoltage Category II. It also complies with the surge requirement
according to EN 61000-4-5 (ne protecon); however, installaon of an addional medium (via local
supply connecon) and/or coarse protecon (external surge protecon) is recommended depending on
the individual applicaon in order to avoid damage caused by overcurrent.
For Canada and US, components used to reduce the Overvoltage Category shall comply with the
requirements of IEC 61643-series. As an alternave, components used to reduce the Overvoltage
Category may comply with ANSI/IEEE C62.11, CSA Cercaon Noce No. 516, CSA C22.2 No. 1, or UL
1449. Suitability of the component for the applicaon shall be determined for the intended installaon.
7. Noce: Corresponding local parcularies and regulaons must be observed. For naonal deviaons,
please refer to the respecve documents included in the manual CD that is delivered with the unit.
8. Note: For a Class B digital device or peripheral:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protecon against
harmful interference in a residenal installaon. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instrucons, may cause harmful
interference to radio communicaons. However, there is no guarantee that interference will not occur in
a parcular installaon. If this equipment does cause harmful interference to radio or television
recepon, which can be determined by turning the equipment o and on, the user is encouraged to try
to correct the interference.
9. Noce: For a Class A digital device or peripheral.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protecon against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instrucon manual, may cause harmful interference to radio communicaons. Operaon of
this equipment in a residenal area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
10. Note: This unit complies with European standard EN62368-1.
Equipment Symbols Used / Compliance
Please observe the meanings of the following symbols used in our equipment and the compliance warnings
listed in Table 2: Compliance Labels (page 12).
DRAFT: CONFIDENTIAL
Chapter 1: Document Overview
CommScope ERA
®
UAP2 with Fiber Interface Installaon Guide , Release
P/N M0203AB, DRAFT Rev D 11