CommScope ERA UAP2 - Chapter 1. Document Overview; Document Cautions and Notes

Document Overview
This installaon guide describes the Fiber UAP2 that interfaces with a Classic CAN or TEN via an opcal link.
This guide provides a product overview and installaon instrucons for installing the UAP2 ber model.
UAP2 is for indoor installaons only.
In addion, this installaon guide describes the Fiber UAP2 that interfaces with a Classic CAN or TEN via an
opcal link.
Table 1: Supported UAP 2 Models (page 6) lists the UAP2 variants that this installaon guide supports.
TABLE 1: Supported UAP 2 Models
Part Number
1
Model Name
7845389-1009 UAP 2 9/18/21/26 F-DC
7845389-1013 UAP 2 7-8/9/18/21 F-DC
7845389-1016 UAP 2 18/21 F-DC
7845389-1025 UAP 2 17E/19 F-DC
7845389-1028 UAP 2 25T/37T F-DC
7845389-1029 UAP 2 34T/37T F-DC
7845389-1030 UAP 2 25T/34T/37T/37T F-DC
7845389-1031 UAP 2 17E/19/25T/37T F-DC
7845389-1032 UAP 2 7E/17E/19/37T F-DC
7845389-1033 UAP 2 80-85/25T/34T/37T F-DC
7845389-1034 UAP 2 80-85/17E/19/37T F-DC
7845389-1036 UAP 2 35L T/35HT F-DC
Note: For informaon on how to nd the minimum soware requirements for ERA hardware, refer
to Hardware to Soware Mapping Informaon.
Document Cautions and Notes
This document may contain any of the following notes, cauons, and warning icons.
Note:
This symbol without addional icons indicates a general note. Notes provide
informaon about special circumstances.
DRAFT: CONFIDENTIAL
Chapter 1
CommScope ERA
®
UAP2 with Fiber Interface Installaon Guide , Release
P/N M0203AB, DRAFT Rev D 6