CommScope ERA UAP2 - Safely Working with ERA Hardware; Health and Safety Precautions; Property Damage Warnings

Abbreviaon Descripon Abbreviaon Descripon
F Fahrenheit Vac Voltage in Alternang Current
FCC Federal Communicaons Commission Vdc Voltage in Direct Current
Gb Gigabit W Was
GHz Gigahertz WIN Wide-Area Integraon Node
GUI Graphical User Interface WCS Wireless Communicaons Switch
ION Intelligent Opcal Network
Safely Working with ERA Hardware
The following secons provide important informaon that you should read and know before working with
any ERA hardware. Observe all cauons and warnings listed in this secon.
Health and Safety Precautions
Note: A high leakage current ground (earth) connecon to the Power Supply Unit (PSU) is
essenal before making any other connecons to the PSU.
Note: Laser radiaon. Risk of eye injury in operaon. Do not stare into the laser beam; do
not view the laser beam directly or with opcal instruments.
Note: High frequency radiaon in operaon. Risk of health hazards associated with radiaon
from the antenna(s) connected to the unit. Implement prevenon measures to avoid the
possibility of close proximity to the antenna(s) while in operaon.
Property Damage Warnings
Note: Keep operang instrucons within easy reach and make them available to all users.
Note: Only license holders for the respecve frequency range are allowed to operate this
unit.
Note: Read and obey all the warning labels aached to the unit. Keep all warning labels are
kept in a legible condion. Replace missing or damaged labels.
Note: Make sure the unit's sengs are correct for the intended use (refer to the
manufacturer product informaon) and regulatory requirements are met. Do not carry out any
modicaons or t any spare parts, which are not sold or recommended by the manufacturer.
DRAFT: CONFIDENTIAL
Chapter 1: Document Overview
CommScope ERA
®
UAP2 with Fiber Interface Installaon Guide , Release
P/N M0203AB, DRAFT Rev D 8