Figures and Tables
MF0121ACP_uc.docx Manual for Node AM4 Page 5
FIGURES AND TABLES
figure 3-1 Grounding bolt ............................................................................................ 24
figure 3-2 Example for interconnecting cabling for a Node AM4 (combiner with three
pairs of band ports) .................................................................................. 25
figure 3-3 Front view of Node AM4 antenna connections (combiner with three pairs of
band ports) ............................................................................................... 26
figure 3-4 DC Mains connector, PIN assignment ....................................................... 31
figure 3-5 Mains connector, location .......................................................................... 31
figure 3-6 Connecting the CAT5 cable to the Node AM for the local connection....... 33
figure 4-3 Layout of a Node AM4 (combiner with three pairs of band ports), maximum
equipment ................................................................................................ 36
figure 4-4 Node AM4 3-band combiner (850-900, 1800, 2100 MHz) with three pairs of
band ports) ............................................................................................... 37
figure 4-5 Node AM4 2-band combiner (800-900 and 1800-2100 MHz) with two pairs
of band ports ............................................................................................ 38
figure 4-6 Single-band DCM, RF card, low / medium power (left) and high power with
additional DL amplifier (right) ................................................................... 39
figure 4-7 Dual band DCM, RF card (medium power) ................................................ 39
figure 4-8 Dummy card ............................................................................................... 40
figure 4-9 Power supply (DC/DC type), front and back .............................................. 40
figure 4-10 UI-board for general applications, installed.............................................. 41
figure 4-11 UI-board for general applications, top and rear view ............................... 42
figure 4-12 PIN assignment ........................................................................................ 43
figure 4-13 Schematics of external alarm clamps ...................................................... 43
figure 4-14 External cable gland ................................................................................. 44
figure 4-15 Summary alarm relay ............................................................................... 44
figure 4-16 Relay contacts, alarm condition ............................................................... 45
figure 4-17 Schematics of summary alarm clamps .................................................... 45
figure 4-18 UI2 Board kit, layout ................................................................................. 46
figure 4-19 Position of UI2 Board and BBU ................................................................ 47
figure 4-20 Modem installed, exemplary .................................................................... 48
figure 4-21 Cable from the modem to the multiband combiner, exemplary ............... 49
figure 4-22 Modem Kit HC25 / PHS8 / PLS8 Node AM, schematic wiring ................ 49
figure 4-23 Modem Kit MC88/TRM-5 Node AM, schematic wiring ............................ 50
figure 4-24 UI1 Board, position of modem RS232 connector .................................... 50
figure 4-25 SIM-card drawer ....................................................................................... 50
figure 4-26 Installation of modem RV50X................................................................... 51
figure 5-1 Installation of modem onto adapter kit ....................................................... 59
figure 5-2 VSWR module, layout ................................................................................ 61
figure 5-3 VSWR module, position of RF connectors ................................................. 61
figure 5-4 Cover of UI-card with status LED ............................................................... 62
figure 5-5 Status LED and connection cables ............................................................ 62
figure 6-1 Cabinet of a Node AM4 (fan unit backside type) ....................................... 71
figure 6-2 Layout of the Node AM4, example ............................................................. 71
To Next Page
Loading...
General