ComNav Marine 1420 Autopilot System
Document PN 29010012 V1.3
7
Tools Required
The general tools & other items you will
need while installing the system are:
1) Basic Tool Kit
2) Screwdrivers: One Phillips, one
slot-head
3) Wire Cutters: a pair of ordinary wire
cutters suitable for general electrical
work will do
4) Drill and a selection of Drill Bits
5) Small Adjustable Wrench
6) Any tools specific to your boat
7) Miscellaneous fasteners & mounting
hardware, for mounting components
and securing hydraulic lines (see
individual “installation” sections,
below, for specific suggestions)
8) You may also wish to have a supply
of Ty-wraps (aka “zap straps”) for
securing electrical cables
If you purchased a 1420 with a Hydraulic
Reversing Pump, a list of the tools you
will require specifically for the installation
of the Reversing Pump is on page 25.
If you purchased a 1420 with a Rotary
Rudder Feedback you may need one
stainless steel band clamp, of a size more
than large enough to fit around your
vessel’s rudder post. See page 16.
To Next Page
Loading...
