Terminal Operation
7-30
Viewing and Editing SCSI Target / Drive Channel
Move the cursor bar to a Drive channel, then press [ENTER]. Select
“View and Edit SCSI Target,” then press [ENTER].
A list of all the SCSI targets and their current settings will appear.
Press [ENTER] on a SCSI target and a menu list will appear on the
screen.
NOTE:
•
It is only recommended to alter the SCSI target settings when adjustments
should be made to specific devices on a drive channel. You may change the
SCSI parameters for specific drives when mixing different drives or
connecting other SCSI device like a CD-ROM on a drive channel. Please
note that neither mixing drives nor connecting CD-ROM is recommended
for the controller.
Slot Number
Choose “Slot Number”, then press [ENTER]. Enter a slot number,
then press [ENTER] again.
This setting is reserved for the "Fault-Bus" option.
To Next Page
Loading...