xvi
Cylinder/Head/Sector Mapping 9-16
Drive-side Parameters
9-18
SCSI Motor Spin-up 9-18
SCSI Reset at Power-up 9-19
Disk Access Delay Time 9-20
SCSI I/O Timeout 9-20
Maximum Tag Count (Tag Command Queuing) 9-21
Detection of Drive Hot Swap Followed by Auto Rebuild 9-22
SAF-TE and S.E.S. Enclosure Monitoring 9-22
Periodic Drive Check Time 9-22
Idle Drive Failure Detection 9-23
9.2.2
Periodic Auto-Detect Swap Check Time 9-23
Monitoring and Safety Mechanisms
9-25
Dynamic Switch Write-Policy 9-25
View Peripheral Device Status (enclosure modules) 9-25
9.3
Controller Auto-Shutdown – Event Trigger Option 9-26
Logical Drive Integrity - Disk Array Parameters
9-27
Rebuild Priority 9-27
9.4
Verification on Writes 9-28
Chapter 10 Redundant Controller Configuration
Page number:
LCD/Terminal
10.3 Configuration
10-19
Via Front Panel Keypad
10-20
Redundant Configuration Using Automatic Setting 10-20
Redundant Configuration Using Manual Setting 10-21
Starting the Redundant Controllers 10-22
Creating Primary and Secondary IDs 10-22
Assigning a Logical Drive/Logical Volume to the
Secondary Controller
10-23
Mapping a Logical Drive/Logical Volume to the Host
LUNs
10-24
Front Panel View of Controller Failure 10-25
10.3.1
When and How is the Failed Controller Replaced 10-25
Via Terminal Emulation
10-26
Redundant Configuration Using Automatic Setting 10-26
Redundant Configuration Using Manual Setting 10-28
Creating Primary and Secondary IDs 10-29
Assigning a Logical Drive/Logical Volume to the
Secondary Controller
10-29
Mapping a Logical Drive/Logical Volume to the Host
LUNs
10-31
10.3.2
Terminal View of Controller Failure 10-32
When and How is the Failed Controller Replaced 10-34
Forcing Controller Failure for Testing 10-35
RCC status (RCC channels) 10-35
Secondary Controller RS-232 10-35
Remote Redundant Controller 10-35
10.3.3
Cache Synchronization on Write-Through 10-35
Chapter 12 Array Expansion
Page number
12.1 RAID Expansion
12-1
12.2 Mode 1 Expansion: Adding Drive to a logical drive
12-4
To Next Page
Loading...