Compaq External RAID Controller & Subsystem Infortrend - Page 281

Navigation Map
A-5
View and Edit
Configuration Parameters ↕
↕↕ ↕
Communication Status..
RS-232 Port Configuration..
PPP Configuration..
Modem Operation..
Com1 Configuration ..
SNMP Configuration..
Com2 Configuration ..
Modem Status .. PPP Status ..
Baud-rate 38400 Change to 9600 19200 4800 2400?
Comm Route PPP Change to Dir ?
Comm Route Dir Change to PPP ?
Term Emul Enab/Disab Change to Disab/Enab?
PPP Name ..
PPP Password .. Modem Functions ..
Modem Setup ..
Scan/Init Modem Scan/Re-Init Modem
Dial-out Modem
Hang-up Modem
No Modem Port Configured
Communication Parameters.. Caching Parameters..
Host-side SCSI Parameters.. Drive-side SCSI Parameters..
Disk Array Parameters..
Redundant Ctlr Configuration..
Controller Parameters..
Write-Back Cache Enabled/Disabled ..
Optimization for Random/Sequential I/O ?
Auto ~ 128, 256, 512, 1024 1, 2, 4, 8, 16, 32
1, 2, Def (4), 8, 16, 32, 64 1, 2, 4, 8, 16, Def (32), 64, 128, 256
Device Type - Device Qualifier
Support Removable Media - LUN Application -
No Device (0x7f) Direct-access(0)
Sequential(1)
Processor(3)
CD-ROM(5) Scanner(6) MO Device(7)
Storage Array(c)
Unknown (0x1f)
Connected, Support Not Connected
Enabled, Disabled
All Undefined LUN, Undefined LUN-0’s
Sector Ranges - Head Ranges -
Cylinder Ranges -
Variable, 32, 64, 127, 255
Variable, 64, 127, 255
Variable, <1024, <32768, <65536 Cylinders
Loop Only PtoP Only
Loop Preferred
PtoP Preferred
Configure Modem Port.. Modem Operation Modes.. Modem Initialization.. Dial-out Functions..
Deconfigure Modem Port ?
Configure Modem on COM1/COM2 ? Custom ModemInit None-DefaultUsed
Custom Modem Init - None/Replace/Append ?
Custom Init Cmd: AT

Dial-out Command ..
Auto Dial-out on Init Enabled/Disabled Dial-out Timeout 
* seconds ?
Dial-out Retry Count - 
?
Retry Interval- 
minutes ..
Event Condition? All Events/Critical&Warning/Critical Events/Disabled
Community Name - Not Set Trap Destination 1 to 4 Parameters ..
Community Name :

Community Name :

Trap IP Address :

Maximum Queued I/O Count - ***..
LUNs per Host SCSI ID - **..
Num of Host-LUN Connect - **..
Tag per Host-LUN Connect - **..
Fibre Connection Options
Peripheral Dev Type Parameters.
Cyl/Head/Sector Mapping Config..
Dial-out Cmd: ATD
