Compaq External RAID Controller & Subsystem Infortrend - Page 344

Index-5
Mode-1 RAID
Expansion
B-4
Mode-2 RAID
Expansion
B-4
motor spin-up 9-18
Multi-Threaded
Operation
B-3
mute beeper: LCD 5-34
Mute Beeper: terminal 7-34
N
naming logical drive 5-18
naming, controller 7-37, 7-39
navigation keys in
terminal emulation
3-3, 3-11
NRAID, disk spanning 1-3
Number of Tags
Reserved for each
Host-LUN Connection
9-12
NVRAM B-2
O
Operational Theory 2-7
Optimization Mode 2-3, 2-10
Optimization Mode:
LCD
5-1
Optimization Mode:
terminal
7-1
Out-of-Band 3-4, 3-6
Out-of-band
Configuration,
Redundant config.
10-14
P
parity check 5-19, 5-32, 7-
31
Parity Check: LCD 5-32
Parity Check: terminal 7-31
partition, deleting 5-17
partition, logical drive,
deleting
7-17
Partitioning a Logical
Drive/Logical Volume:
LCD
5-12
Partitioning a Logical
Drive/Logical Volume:
terminal
7-11
partitioning the logical
volume
1-15
partitions, mapping
them to LUNs
2-9
pass-through SCSI
commands: LCD
5-22
Pass-through SCSI
Commands: terminal
7-21
password , disabling 7-36
password changing 5-34
Password Validation
Timeout: LCD
5-37
Password Validation
Timeout: terminal
7-39
password, setting a
new
7-35
Periodic Drive Check
Time
9-22
periodic drive swap
auto check
9-23
Peripheral Device Type 9-14
Peripheral Device Type
Parameters for Various
Operating Systems
9-15
Peripheral Device Type
Settings
9-16
Perpetual Clone, Clone
Failing Drive
9-3
Perpetual Clone:
S.M.A.R.T.
9-6
Primary and Secondary
Controller ID: Fibre
8-6
Primary Controller 10-16
primary controller,
setting SCSI ID/drive
channel for
7-27
primary ID, SCSI
channel setting: LCD
5-27
Primary/Secondary
Controller ID: terminal
7-26
Q
Quick Installation: LCD 4-1
Quick Installation:
terminal
6-2
R
RAID 7-6
RAID (0+1) 1-17
RAID (3+0) 1-17