Compaq External RAID Controller & Subsystem Infortrend - Page 346

Index-7
Disks: terminal
Scanning New Drive:
terminal
7-23
Scanning New Drive:
LCD
5-23
SCSI channel ID,
deleting
5-27
SCSI channel ID,
setting
5-26
SCSI channel primary
ID, setting
5-27
SCSI channel
secondary ID, setting
5-28
SCSI channel
terminator
5-28
SCSI channel
terminator
7-28
SCSI channel,
explained
9-11
SCSI Channel’s Status:
terminal
6-7
SCSI channels, viewing
and editing
7-25
SCSI commands,
pass-through
5-22, 7-21
SCSI Drive Information:
terminal
7-42
SCSI Drive Low-level
Format: LCD
5-40
SCSI Drive Low-level
Format: terminal
7-43
SCSI Drive Read/Write
Test: LCD
5-41
SCSI Drive Read/Write
Test: terminal
7-44
SCSI Drive Status:
LCD
4-4
SCSI Drive Utilities:
LCD
5-40
SCSI Drive Utilities:
terminal
7-42
SCSI Drive’s Status:
terminal
6-6
SCSI drives, viewing
and editing
7-22
SCSI I/O Timeout 9-20
SCSI ID, deleting 7-27
SCSI Motor Spin-Up 9-18
SCSI Parameters 2-10
SCSI Reset at Power-
Up
9-19
SCSI target/drive
channel, viewing and
editing
5-30
SCSI target/drive
channel: LCD
5-30
Secondary Controller 10-16
Secondary Controller
ID
8-6
secondary controller,
setting SCSI ID/drive
channel
7-28
secondary ID SCSI
channel, setting
5-28
Serial Port 3-1
serial port: connection
and setup
3-1, 3-6
Setting a New
Password: terminal
7-35
Setting a Primary
Controller’s SCSI ID:
terminal
7-27
Setting a channel’s ID:
LCD
5-26
Setting a channel’s
Primary ID: LCD
5-27
Setting a channel’s
Secondary ID: LCD
5-28
Setting a SCSI
channel’s Terminator:
LCD
5-28
Setting Transfer
Speed: LCD
5-29
Setting Transfer Width:
LCD
5-30
Shutdown Controller:
LCD
5-35
Single drive control 1-3
Slot number: LCD 5-31
Spanning 1-3
Spare drive 2-4
Spare Drive
Assignments: LCD
5-7~8
Spare Drives 1-6, 1-11, 1-
14
Spin-Up Parameters 2-10
Stripe size B-1
Striping 1-4
Sun Solaris
configuration
9-16
Synchronized cache B-6
System Functions: LCD 5-34
T
Tag Command Queue B-3