4-13
ProLiant 3000 Setup and Installation Guide
Writer: Tom Erber Project: ProLiant 3000 Setup and Installation Guide Comments: 296908-002
File Name: E-CH04.DOC Last Saved On: 1/27/98 4:20 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
3. Unlock the server, open the front panel, and slide the front panel up and
away from the server.
Figure 4-11.
Removing the front panel
4. Loosen the thumbscrews on the front of the drive cage.
5. Pull out the latch at the back of the drive cage (shown in Figure 4-13)
and pull out the drive cage 2 to 3 inches to allow better access to cables.
To Next Page
Loading...
