2-8 l Descript ion
Carousel Plus W Series
Dehumidifying Dryer Options
• Volatile trap (only in conjunction with aftercooler/intercooler) - The volatile
trap is recommended if drying materials that produce volitales that condense
into a waxy or oily residue and/or if the material contains excessive fines.
• Precooler - The precooler reduces the temperature of air after the desiccant
wheel and before the process heater, which enables the dryer to control
temperatures at low setpoints, (100º - 150ºF {38º - 66ºC})
• Filter check - The filter check sensor will activate a passive alarm when the
process filter is clogged or needs to be replaced.
NOTE: Temperature setback is only available in conjunction with the Hopper Temperature
Controller (HTC) or the ResinWorks system.
✐
To Next Page