Conair W600 - Connecting the Dryer to the Hopper

3
Installa tion
Installa tion l 3-15
Connecting the Dryer to the Hopper
If your dryer hose connection and your hopper HTC hose connection are not the
same size, you will need a hose adapter. Contact Conair Parts 1 800-458-1960.
Connecting the Dryer to
ResinWorks
If your dryer hose connection and the connection on your ResinWorks sled are not
the same size, you will need to use a hose adapter. Contact Conair Parts
1 800-458-1960.
NOTE: Because the W600 - 5000 models require a separate heat source for the
delivery air, all references to this heat source will be identified as “HTC” (Hopper
Temperature Controller). When using this dryer with a HTC, reference the User
Guide supplied with the HTC for installation instructions.
✐
NOTE: Because the W600 - 5000 models require a separate heat source for the
delivery air, all references to this heat source will be identified as ResinWorks.
When using this dryer with a ResinWorks sled reference the User Guide supplied
with the ResinWorks sled for installation instructions.
✐