Conair W600 - C L E a N I N G T H E a F T E R C O O L E R; I N T E R C O O L E R C O I L S; Cleaning the Aftercooler;Intercooler Coils

Maintenance l 5-9
5
Maintenance
Cleaning the Aftercooler/
Intercooler Coils
You need to clean the aftercooler/intercooler coils to keep them working efficient-
ly. Cleaning frequency depends on the type and amount of material you process.
1 Stop the dryer and lockout the main power.
2 Turn off the water flow to the water supply line. Disconnect
supply and return lines.
3 Remove the bolts securing the aftercooler/intercooler cover. Remove the
cover.
4 Remove the aftercooler/intercooler by pulling it out of the aftercooler/inter-
cooler housing.
W600 - 1000
Models
W1600 - 5000
Models
NOTE: If an optional flow control was added with the aftercooler/intercooler, remove the
compression fitting from the aftercooler/intercooler inlet. Loosen the fitting on the flow
control, then swing the copper water supply tube out and away from the
aftercooler/intercooler inlet.
✐
(continued)