3. Hardware Description
PC-686BX(NLX)-LV, PC-686BX(NLX)-LVV
13
3.
Hardware Description
This chapter describes the board jumper settings and connectors required to setup the
board for operation.
Installation Procedure
(1) Install the processor making sure it is oriented correctly.
(2) Install the DRAM modules making sure they are oriented
correctly.
(3) Attach the fan above the processor and plug into the fan
connector.
(4) Insert all external cables other than for the flat panel
(VGA, hard disk, floppy, keyboard, mouse, LAN, etc.)
(5) Connect a CRT monitor to use for the CMOS setup.
(6) Confirm that the backplane power is turned off.
(7) Insert the CPU board into the backplane.
(8) Turn on the power.
(9) As the system starts to boot, hold down the DEL key to enter
BIOS setup mode.
(10) Set the peripheral setup and standard setup to the correct
settings.
Note!
The CMOS memory may be initialized to an undefined state if the
non-battery backup period has elapsed.
“Cmos Checksum error” may be founded when you are using at first time. When will
you find it , please hold down the DEL key to Setup BIOS .
To Next Page
Loading...
Need help?
General
