7. BIOS Setup
PC-686BX(NLX)-LV, PC-686BX(NLX)-LVV
85
Keyboard error or no keyboard present
Unable to initialize keyboard. Check that the keyboard is connected correctly and
that no keys are pressed when the computer boots.
When intentionally configuring a system with no keyboard, set the Setup error
handling setting to "HALT ON ALL, BUT KEYBOARD" (halt on all device errors
except from the keyboard). In this case, the BIOS continues to boot if it does not find
a keyboard.
Memory address error at…
This indicates that a memory address error occurred at a specific address. By
matching this address information with the system memory map, you can identify and
replace the faulty memory chip.
Memory parity error at…
This indicates that a memory parity error occurred at a specific address. By matching
this address information with the system memory map, you can identify and replace
the faulty memory chip.
Memory size has changed since last BOOT
Memory has been added or removed since the last time the system was booted. In
EISA mode, use the configuration utility to reset the memory configuration. In ISA
mode, enter Setup and set the new memory size in the memory field.
Memory verify error at…
This indicates that an error was detected when verifying values previously written to
memory. By matching this address information with the system memory map, you
can identify and replace the faulty memory chip.
Offending address not found
This message is displayed with I/O channel check messages and RAM parity error
messages if the segment in which the problem occurred cannot be identified.
Offending segment
This message is displayed with I/O channel check messages and RAM parity error
messages if the segment in which the problem occurred can be identified.
To Next Page
Loading...
Need help?
General
