Installation 3
Installation
System requirements
PC or supported workstation.
Compatible Windows operating system – View the ws/readme.htm file on the WIDEsystem TOOLS CD-ROM.
PC with USB port or enabled FireWire Port.
The WIDEsystem TOOLS CD supplied with your scanner.
Scanning software or compatible third party software.
Grounded power outlet.
Installation Steps
To get your scanner up and running, follow the steps below in their written order.
Set up the scan station
Your scanner should be placed either on the specially designed stand-alone floor
stand or on a sturdy table. Make sure there is enough space behind the scanner to
allow the media to run out.
IMPORTANT: DO NOT YET CONNECT THE SCANNER TO
POWER OR PC.
See also the Safety Instructions at the end of this operator’s
guide
1
To Next Page
Loading...
