Control Module Genus G1 Mark II - WiFi Module Setup Screens; Enable DHCP Setting; WiFi Network Parameter Entry

Genus G1 MARK II Users Manual
UM3010-2
WiFi Module Setup screens
The Genus terminal needs to be in the Offline mode to get to the WiFi setup.
Enable DHCP: No – disables DHCP and
requires the user to enter network
parameters. Yes – enables DHCP and the
network parameters are assigned by the
DHCP server.
With DHCP disabled the Terminal will
prompt for network settings.
IP: This is the IP address of the WiFi
Module.
Note: To communicate to the Terminal
you need to use the Terminal IP, which is
assigned through the Network Setup
menu.
Subnet Mask:
Gateway IP:
Primary DNS:
Secondary DNS:
Revision B 10-30-07 37
WIFI NETWORK SETUP
<UP><DWN><E><H>
ENABLE DHCP
No
WIFI NETWORK SETUP
<0-9><E>
WIFI MODULE IP:
192.168.000.068
WIFI NETWORK SETUP
<UP><DWN><E>
SUBNET MASK:
255.255.255.0
WIFI NETWORK SETUP
<0-9><E>
GATEWAY IP:
000.000.000.000
WIFI NETWORK SETUP
<0-9><E>
PRIMARY DNS:
192.168.000.001
WIFI NETWORK SETUP
<0-9><E>
SECONDARY DNS:
000.000.000.000
WIFI NETWORK SETUP?
<UP><DWN><E>