Control Module Genus G1 Mark II - SSID Configuration; SSID Details and Case Sensitivity; Security Type Configuration; Security Type Options

Genus G1 MARK II Users Manual
UM3010-2
SSID: The default value for the SSID is
“any”. The SSID can be up to 31
characters. This controls which AP the
Module connects to. If using a digital
wand refer to the Code 39 Programming
Table in this document.
Note: The SSID is case sensitive.
Security Type: The default is set to
disabled. However, the Module provides,
wep64, wep128, wpa-psk, options. See
WiFi Module Security Settings, in this
manual.
Save Changes? Changes saved by ‘E’
will be saved to the WiFi Module. ‘H’
aborts the setup changes placing the user
at the first prompt for DHCP
enable/disable.
WiFi Module Fallback Settings
Fallback mode can occur when the WiFi module is unable to associate with an access point
after 60 seconds. When fallback occurs the Terminal recognizes the fallback settings and will
allow a setup session to change the WiFi parameters.
WiFi Module Fallback LED Indication
The LEDs on the Module revert to the Power LED changing from amber to green and the
Link LED will continue to blink red.
Enable DHCP: If fallback has occurred,
choosing “Yes” while in WiFi Network
Setup will bring up the FALLBACK
SETTINGS prompt.
If “Yes” is entered the fallback settings
stored in the Module become available to
change. If “No” is entered the Module
returns to the SSID prompt.
Fallback IP: Default is 192.168.000.068.
Revision B 10-30-07 38
WIFI NETWORK SETUP
<UP><DWN><0-9><E>
SSID:
any
WIFI NETWORK SETUP
<UP><DWN><E>
SECURITY TYPE:
disable
WIFI NETWORK SETUP
<E><H>
SAVE CHANGES?
‘E’=SAVE ‘H’=ABORT
WIFI NETWORK SETUP
<0-9><E>
FALLBACK IP:
192.168.000.068
WIFI NETWORK SETUP
<UP><DWN><E><H>
ENABLE DHCP
Yes
WIFI NETWORK SETUP
<UP><DWN><E>
FALLBACK SETTINGS:
Yes