Control Module Genus G1 Mark II - WEP64 Configuration; WEP64 Security Details; WEP Authentication Types; Default WEP Key Selection

Genus G1 MARK II Users Manual
UM3010-2
WEP64 refers to 64-bit key length
assigned to the WiFi Module that must
match the access point on the network.
The WEP Authentication type can be
configured for auto, open or shared. Auto
is the default and will automatically detect
the authentication. Open authenticates
using open Key algorithm, and will
communicate the key across the network.
Shared authenticates using Shared Key
algorithm, and will allow communication
only with devices with identical WEP
settings.
The Default Key option must match the
key index configured on the Access Point.
The options are 1, 2, 3, 4, with the default
set to 1.
There are four WEP Key input areas to
add the ASCII HEX values. These
correspond to the numbers as chosen
through the default key above. WEP 64
requires 10 hex digits. Default is shown.
Acceptable characters include only 0-9,
and A-F, in upper case.
If using a digital wand refer to the Code
39 Programming Table in this document.
Revision B 10-30-07 41
WIFI NETWORK SETUP
<UP><DWN><0-9><E>
SECURITY TYPE:
wep64
WIFI NETWORK SETUP
<UP><DWN><E>
AUTHENTICATION:
auto
WIFI NETWORK SETUP
<UP><DWN><0-9><E>
WEP KEY 1:
0
WIFI NETWORK SETUP
<UP><DWN><E>
DEFAULT KEY:
1
WIFI NETWORK SETUP
<UP><DWN><0-9><E>
WEP KEY 2:
WIFI NETWORK SETUP
<UP><DWN><0-9><E>
WEP KEY 3:
WIFI NETWORK SETUP
<UP><DWN><0-9><E>
WEP KEY 4: