Genus G1 MARK II Users Manual
UM3010-2
Time Zone
The Time Zone is normally set during Terminal setup and cannot be changed in the Web
Browser Interface.
Total RAM
The Total RAM displayed refers to the total amount of dynamic RAM available for program
execution. Free RAM refers to the amount of dynamic RAM remaining at that point in time.
File Versions and Fields
The fields adjacent to the Genus Version, Classes Version, Application Version, Lib 1, 2, 3
and CMTML File Versions are editable fields that accept a URL to point to a new version of
that file represented. The Reload button uses the URL to retrieve the new file and loads it to
the Terminal. A URL example could be as follows ‘www.example.com/genus’. More than
one file can be reloaded during a session. When all reloads are complete the Terminal can
be rebooted by selecting the Reset Terminal button at the bottom of the Genus
Administration page.
Web Server Configuration
The Web Server Configuration Section has two settings Enable/Disable Web Browser
Interface and Enable/Disable Web Service Interface. The Enable Web Browser Interface is
enabled by default and the checkbox is checked. The Enable Web Service Interface setting
is independent of the Browser and is disabled by default. The checkbox is not checked.
Note: Both Settings Enable Web Browser Interface and the Enable Web Service Interface
can also be set through the Web Setup in Offline mode on the Terminal.
User Name and Password
Username and password fields are provided and should be changed from the Username and
Password defaults configured on the Terminal. Username and Password is not case
sensitive.
Port
Port is the default (web port) TCP port for the Web Browser Interface.
Save Settings Button
Settings changed on the Genus Administration page are saved to the Terminal when this is
selected.
Reset Terminal
This is required to have new settings take effect. Some settings may take some time to
complete. If the Terminal is reset the Web Browser should also be closed and restarted to
pickup any new settings. Settings should be saved prior to resetting the Terminal.
Logout
Will logout from the current session. If changes are made on the Genus Administration page
and not saved they will be lost during logout.
Revision B 10-30-07 45
To Next Page
Loading...