Form 6 Microprocessor-Based Pole Mount Recloser Control Installation and Operation Instructions
54
Replacement Kits
Replacement kits for the Form 6 pole-mount control are
available through the factory Service Department. To order
these kits, refer to the Replacement Parts price list for
catalog numbers and pricing. Contact your Cooper Power
Systems representative for additional information and order
procedures.
Factory-Authorized Service
Centers
Factory-authorized service centers are located throughout
the continental United States to provide maintenance,
repair and testing services for Cooper Power Systems
controls and reclosers. For further information, contact
your Cooper Power Systems representative.
Factory Maintenance Classes
The factory service department offers a basic testing and
troubleshooting course for the Form 6 microprocessor-
based electronic recloser control. This course, taught by
experienced service technicians, is held at the factory’s
in-house training facility. For additional information, contact
your Cooper Power Systems representative.
Type MET Recloser Control Tester
A 30-minute video program KSPV7 Kyle Type MET
Electronic Recloser Control Tester Operation and Testing
Procedures is available as a supplemental training aid for
service personnel.
CAUTION: This equipment requires routine
inspection and maintenance to ensure proper
operation. If it is not maintained, it can fail to operate
properly. Improper operation can cause equipment
damage and possible personal injury. G105.1
ADDITIONAL INFORMATION
To Next Page
Loading...
Need help?
General
