Cornelius IDC PRO 255 - Service Mode Entry

IDC Pro 255 Service Manual
© 2016, Cornelius Inc. - 21 - Publication Number: 621058649SER
PREPARING FOR OPERATION
SERVICE MODE
The Service mode is used to perform all of the maintenance and troubleshooting for the unit. There are three menu
levels available depending on the classification of the operator.
Figure 38 shows the service mode screen for opera-
tors, service mode screen for supervisors and shows the service mode screen for service technicians. To enter the
service mode, perform the procedure in Table 15.
Table 15.
Step Action
1
Display the keypad screen by tapping each cor-
ner of the video screen Starting in the upper right
corner (1) and continuing to tap each corner in a
Counter clockwise direction in a sequence of
1,2,3 and 4 as shown in Figure 36.
NOTE: As each corner is touched, a small
confirmation rectangle may
momentarily appear to confirm the
touch.
Figure 36.
2
Input the proper password for your access
level (operator, manager or technician) and
press Enter. The Service UI screen is dis-
played, as shown in Figure 38 depending on
your access level.
Figure 37
1
2
3
4
5
6
7
8
9
0
Enter
<