corob D600 - Page 11

FEATURES
- 11 -
COROB™ D600 - D700 - D800TX
Can centering device
On the machine accessorized with punching system, a centering device is mounted
on the shelf. The can centering device is custom-made based on the size of the
cans to be handled and is useful for aligning them with the nozzle center, so that
the can lid is punched in the middle and dispensing takes place precisely into the
hole created. The can centering device is also available as an optional accessory
to the standard machine, useful for positioning pre-punched cans right under the
dispensing center.
Bung Hole Locator (B.H.L.)
This is a system that emits laser beams that allow the positioning of pre-punched
cans, so that the hole is in line with the center of the dispensing nozzles.
Nozzle Humidier Cap
Colorants tend to dry out; this tendency may be more or less strong depending
on the type of colorant and the environment conditions (temperature, relative
humidity, etc.). To prevent colorants from drying out in the nozzle center, the
machine is equipped with a humidier cap which requires constant maintenance.
The Lift-up Autocap is an automatic humidier cap which ensures that the
nozzles are hermetically sealed. It is managed by the software, which opens
it automatically before dispensing and closes it immediately afterwards.
Manually-operated automatic puncher
The puncher is a device that perforates the can lid. Punching is carried out by
the operator by pushing contemporaneously the semiautomatic shelf activation
buttons (two-handed control); thanks to the upward movement, the shelf pushes
the can resting on it against the puncher, and with a downward movement brings
it to the correct position for dispensing.
No-Dry-Nozzle Humidier System
The humidier system for water-based colorants guarantees the nozzles are
humidied not only with Autocap closed but also during dispensing. The air,
humidied by the water contained in the bottle, is transferred to the nozzles
area. Based on the humidity level detected, the system activates or shuts off
whenever needed.
The humidier system for solvent-based colorants humidies the nozzles when
Autocap is closed. The solvent, contained in a small tank inside the Autocap,
keeps the nozzles area constantly saturated.
The two systems can be used individually or together according to the tinting
system used on the machine.