SHIPPING AND HANDLING
- 21 -
COROB™ D600 - D700 - D800TX
4 SHIPPING AND HANDLING
4.1 General warnings
Personnel in charge of these operations must wear the following personal protective
equipment.
DANGER
To avoid personal injuries and property damage, use the utmost care and caution when handling the machine,
and carefully follow the instructions given in this chapter.
Do not insert the forks of the lift truck into the long side to lift the packing.
WARNING
The packing must be handled only by qualied personnel using appropriate handling equipment. Do not stack
items on the packing.
If the machine is installed near a wall, keep it at least 4” (10 cm) away to prevent the cables from being
crushed.
4.2 Unpacking and placement
1 x 10 mm
2 x 17 mm
To remove the xing brackets
DANGER
The following procedure must be carried out by at least 2 people.
Store the packing material for future use, or dispose of it according to current regulations. In any case, we
recommend that you keep it for the entire duration of the machine warranty.
Make sure the packing has not suffered any damage or tampering during shipping; if so, contact the
authorized technical service or your dealer.
1. Cut the straps wrapped around the packing.
2. Remove the covering from the pallet.
FRONT SIDE
7261112674
To Next Page
Loading...
