corob D600 - Safety Guidelines; Safety Warnings and Unauthorized Use

SAFETY
- 15 -
COROB™ D600 - D700 - D800TX
3 SAFETY
3.1 Safety warnings and unauthorized use
COMPULSORY
• Read the user’s manual carefully before carrying out any operation on the machine.
• The machine must be used only for its intended purpose.
• Pay close attention to the signs on the machine.
• When prescribed, wear personal protective equipment.
• Only qualied and appropriately trained personnel (MAINTENANCE TECHNICIAN) are authorized to access the
machine parts protected by panels for extraordinary maintenance and repair interventions.
• Any routine maintenance intervention performed by the operator must be carried out with the machine off
and the power supply cable disconnected from the mains socket outlet.
• The machine must be used by a single operator. Unauthorized people who could reach or touch machine
parts during operation must not be admitted in the nearby area.
• The machine must be used by an operator who has attained the age of majority and is in suitable psychophysical
conditions dened by an occupational physician.
• The substances that may be used on the machine -- such as colorants, paints, solvents, lubricants and
cleansers -- may be hazardous to your health; handle, store and dispose of these substances in keeping with
current regulations and the instructions provided with the product.
PROHIBITED
• The machine must not be used with cans exceeding the limits set forth in chapter 2.4 (Usable cans) and with
colorants other than those specied in the technical data table.
• THE MACHINE MUST NOT BE USED IN AREAS AT RISK FOR EXPLOSION.
• The machine must not be employed for food use.
• The OPERATOR must not carry out operations reserved to the MAINTENANCE TECHNICIAN or the
INSTALLATION TECHNICIAN. The manufacturer CANNOT BE HELD RESPONSIBLE for damages deriving from
the non-observance of this prohibition.
• It is strictly forbidden to use the machine without protections or with any safety devices present on the
machine disabled, broken down, or removed. The panels must be kept closed at all times.
• Do not stare the light source of the Laser Bung Hole Locator (Class II laser product).
• If the machine catches re, never use water. Use only dry powder or carbon dioxide re extinguishers, and
strictly follow the instructions and warnings indicated by the manufacturer and listed on the extinguisher.
ELECTRICAL DANGER
• ALWAYS PLUG THE MACHINE INTO A SOCKET THAT ENSURES PROPER GROUNDING. The line must
be protected from overloads, short-circuits and direct contacts according to current accident prevention
regulations. Incorrect grounding may lead to the risk of electrical shock.
• The machine must not be powered by a power source having specications other than those listed on the
identication plate.
• In the event of a sudden power outage, when power returns the machine will automatically be switched on
to allow the automatic processes to prevent products from drying out.
• To prevent any risk of electrical shock or injuries, use the machine indoors only. It is prohibited to use the
machine outdoors where it could be subjected to rain or high humidity.
• Always unplug the power supply cable from the socket outlet before carrying out any maintenance operations.
• The machine is isolated from the power supply line when the power cable is disconnected; it must therefore
be installed near an easily accessible mains socket outlet.
• Do not use extension cords to power the machine.