TWIN DISC CENTRIFUGAL FERTILIZER SPREADER - FERTI 1500/2150/2400/2800/3200
TWIN DISC CENTRIFUGAL FERTILIZER SPREADER - CX 1500/2150/2400/2800/3200
TWIN DISC CENTRIFUGAL FERTILIZER SPREADER - CX 1500/2150/2400/2800/3200
TWIN DISC CENTRIFUGAL FERTILIZER SPREADER - CX 1500/2150/2400/2800/3200
TWIN DISC CENTRIFUGAL FERTILIZER SPREADER - CX 1500/2150/2400/2800/3200
Cod. MNenA055CER05 Rev. 05/05.2018 © A
rex S.p.A.
6-10
WARNING!
Toobtainagooduniformityofspreaderusefertilizerswitharegulargranulometry.Thevalues
cannotablychangeaccordingtotheenvironmentalconditionsduringtheworkingphase:the
presenceofwindoranyirregularitiesinthefiledmayaffecttheuniformityofspreading.
Thetestscarriedoutbyushave
beenmadewithoptimumweatherconditions,intotalab sence
ofroughnessofthefieldandusingfertilizerswithsmallvariationsongranulometry.
6.5.
OPERATOR’SDRIVINGTECHNIQUE(DRIVINGONTHEFIELD)
The quality of spreading depends greatly on the operator’s driving technique.
s Near the headlands and during the manoeuvres, stop the spreading and disengage the power take-off (PTO). In order to avoid
spreading fertilizer outside the edges of the field, switch spreading back on again only after approaching the end of the field at
a distance equal to the maximum rear spreading length.
s
Grains of fertilizer are very lightweight and their trajectory of movement varies with the amount of wind. For this reason, stop
spreading when wind speed is too high, otherwise the distribution of the fertilizer spread over the soil will be irregular.
L
Working width
12 m
(
*
)
18 m
(
*
)
24 m
(
*
)
32 m
(
**
)
36 m
(
***
)
Spreading widht
24 m 36 m 48 m 64 m 72 m
L/2
Distance from the edge of the field
6 m 9 m 12 m 16 m 18 m
P
Step
Q1
Spreading starting point
Q2
Spreading end point
1
Sequences
Normal spreading (180°)
Border spreading with limiter activated
(
*
)
with kit discs 12-24 meters
(
**
)
with kit discs 25-32 meters
(
***
)
with kit discs 33-36 meters
06‐USINGTHEMACHINE
To Next Page
Loading...
Need help?
General