Cotech FT0203 - Sensor Functionality Check

12
ENGLISH
Searching for sensors and checking thesensors’
functionality
When theindoor unit is turned on, anautomatic search for nearby sensors will begin.
Thesearch is indicated by . If you have more than one thermometer/hygrometer,
thedisplay will alternate between these as they are registered. When thesymbol
disappears, you can test that thesensors are working.
Information
If, when searching, theweather station is unable to find asensor, or if it loses contact
with asensor, “--.-” is shown on thedisplay. Perform amanual search for asensor:
1. In normal mode, press and hold [ CHANNEL/+ ] for 3 seconds. “REG” appears on
thedisplay.
2. Press [ CHANNEL/+ ] or [ HISTORY/- ] to select thermometer/hygrometer (CH1−8),
anemometer (WIND), rain gauge (RAIN), all sensors (ALL) or, to cancel thesearch,
(NOT). Confirm your selection by pressing [ MODE/SET ].
Anemometer
1. Test thesensor for wind speed
by spinning thecups. Check that
thevalue shown on thedisplay
changes.
Rock therain gauge’s measuring cup
back and forth. Each time themeasuring
cup tips over represents 0.3mm of
precipitation. Check that thevalue shown
on thedisplay changes.
2. Test thesensor for wind direction by
changing theposition of theweather
vane. Check that thedirection
shown on thedisplay changes.
Rain gauge