Cotech FT0203 - Toggle between External Temperature;Hygrometer Sensors; Max;Min; Reset Measurement Values

19
ENGLISH
Toggle between external temperature/hygrometer sensors
• In normal mode, press [ CHANNEL/+ ]
repeatedly to switch between connected
thermometers/hygrometers. Therelevant
channel number will be shown on
thedisplay.
• For therolling display of all sensors,
press [ CHANNEL/+ ] until
appears
on thedisplay. Theweather station will
now display values from each connected
sensor at 5-second intervals.
Max/Min
1. In normal mode, press [ MAX/MIN/ALARM ] once. “MAX” will be shown on
thedisplay, together with themaximum values for precipitation, wind speed,
pressure, temperature and humidity.
2. Press [ MAX/MIN/ALARM ] again. “MIN” will be shown on thedisplay, together with
theminimum values for pressure, temperature and humidity.
When displaying max/min values, press [ HISTORY/− ] to toggle between thedisplay
modes for precipitation and air pressure.
Reset measurement values
Max/Min values
Note:
When resetting maximum/minimum values, thestored values for all sensors will also
be reset.
1. In normal mode, press [ MAX/MIN/ALARM ] repeatedly to select MAX or MIN.
2. Press and hold [ MODE/SET ] for 3 seconds (CLR flashes) in order to reset themax
or min values respectively.
To reset themax/min values automatically, see theSettings/adjustments section (CLR).
Precipitation
1. In normal mode, press [ MODE/SET ] twice to select thedisplay mode for precipitation.
2. Press [ CHANNEL/+ ] or [ HISTORY/− ] repeatedly to select thedisplay mode.
3. Press and hold [ MODE/SET ] for 3 seconds to reset theselected value.
Memory
To clear theweather station’s memory, see theSoftware (WeatherHome) section.