9
ENGLISH
Rain gauge
1. Remove thewater collector by turning it in thedirection of thearrow and then
lifting it upwards.
2. Remove thebattery cover. 3. Insert 4×AAA/LR03 batteries.
Theunit will begin to transmit data once
every 60 seconds.
4. Replace thebattery cover.
Thermometer/hygrometer
Note:
• If you are to connect any additional thermometers (other than that which is supplied),
these must be set so that they transmit on different channels. This is done by
altering theDIP switches in thebattery compartment. Atotal of 8 thermometers
may be connected.
• Ensure that theDIP switches have been set before you insert batteries into thesensor.