38
CraftBot 3
30.- G104: Extrude width timeout: E T
31.- G195: Reset motion.
32.- G196: Reset all.
33.- G197: Pause.
34.- G198: Resume.
35.- G199: Imadiate pause.
36.- G194: Imadiate abort.
37.- M18: Disable stepper motors.
38.- M82: Set extruder to absolute mode.
39.- M83: Set extruder to relative mode.
40.- M84: Stop idle hold: S
41.- M8484: Motors o imadiate: S
42.- M105: Get temperature of extruders and bed: P T 43.- M106: Turn cooling fan on: S T
44.- M116: Turn cooling fan on: H L S T
45.- M104: Set extruder temperature: Q S T
46.- M109: Set and wait head temperature: Q S T 47.- M1400: Start heating and waiting: B E H P Q T
48.- M107: Turn cooling fan o.
49.- M110: Print Start or Stop: S
50.- M114: Get current position.
51.- M115: Get rmware version.
52.- M117: Display message.
53.- M140: Set bed temperature: H L S
54.- M190: Set and wait bed temperature: S
55.- M220: Set speed override percent: S
56.- M221: Set extrusion override percent: S
57.- M300: Play beep sound: P S
58.- M424: ...: E F
59.- M423: ...: E F T
60.- M422: Start Head Preparation.
61.- M425: Set nozzle wipe position: S
62.- M430: Head change ZHop settings: F Z
63.- M431: Head change Exit Retract settings: E F
64.- M432: Head change Enter Retract settings: E F
65.- M433: Head change Enter Prime settings: E F
66.- M450: Self test: E F
67.- M900: Linear advance beta version: A D K
68.- M905: Set feed High/Low: H L
69.- M73: M73 progressbar refresh: P S
70.- M1001: Get Printer Version.
71.- M1002: Get unique ID: S
72.- M1003: Get rmware version: S
73.- M1004: Get HMI version.
74.- M1005: Get HMI board version: S
75.- M1006: Set limits s=1 Case / S=2 Head: H L S T
76.- M1014: Get ADC values: S
To Next Page
Loading...
