39
CraftBot 3
77.- M1015: Get PWM duty.
78.- M1020: Puer mode: S
79.- M1104: Get Info: P
80.- M1105: Get HMI mode.
81.- M1106: Set HMI mode.
82.- M1114: Get machine coordinates.
83.- M1115: Get queue.
84.- M1116: Set Min Q: Q
85.- M1123: Set T7 pin high or low: S
86.- M1160: Fan control (Case,Dome,Head,Obj): C D H O T 87.- M1161: Fan override: S
88.- M1200: Set feed properties: F H L
89.- M1202: Set axis soft limit: E X Y Z
90.- M1203: Set XY acceleration: A D F
91.- M1204: Set Z acceleration: A D F
92.- M1210: Set extruder correction: F K
93.- M1211: Set extruder correction: F K
94.- M1212: Set thermal runaway: Q S
95.- M1297: Mem dump: S
96.- M1298: Send command: S
97.- M1299: Queue report: S
98.- M1300: Set extruders PID: D F I P W
99.- M1301: Set bed PID: D F I P W
100. - M1401: Seat head heating curve: D Q
101. - M1402: Seat bed heating curve: D Q
102. - M1403: Flush.
103. - M1800: Set HMI Baud: S
104. - M1885: Set G1 counter: S
105. - M1886: Read restart data.
106. - M1887: Read startup GPBR.
107. - M1888: Backup: Q S
108. - M1889: Set RTC: D S
109. - M2001: Set max imp: E X Y Z
110. - M2002: Set ref imp: X Z
111. - M2003: Soft Enable encoder: S
112. - M2004: Enable encoder check: S
113. - M2005: Set encoder div: Q S
114. - M2006: Set encoder calibstate: S
115. - M2007: Encoder autoset: S
116. - M2008: Set encoder params: Q S
117. - M3000: Get X Y Z jupers states: J X Y Z
118. - M3001: Set LED szalag: L
119. - M3002: Set LCD light: L
120. - M4001: Set heating overlap: P
121. - M4003: Set maximum head heat temp: H S
122. - M4004: Get heat state: S
To Next Page
Loading...
