To Next PageTo Next Page
Need help?Do you have a question about the Crane Electronics DTT Opta and is the answer not in the manual?
General| Brand | Crane Electronics |
|---|---|
| Model | DTT Opta |
| Category | Other |
| Language | English |
Details battery type, charging times, and LED indicators for different models.
Summarizes the extensive features of the TorqueStar Opta, including measurement modes and optional functions.
Details power, weight, construction, output, and physical dimensions of the TorqueStar Opta.
Lists accuracy, overload capacity, zero drift, operating temp, stability, sealing, humidity.
Covers serial interface, frequency response, calibration, warranty, and servicing details.
Specifies input and output power for standard and fast charge mains adaptors.
Identifies screen, LEDs, keypad, securing lugs, and charging status indicators.
Details connectors for mains charger, PC/printer cable, and transducer cable at the rear.
Explains the function of Cancel, Arrow, Enter, and Alpha-numeric keys for device control.
Guides on connecting the Opta to a PC or serial printer using specific cables.
Explains the caution, procedure, and confirmation for performing a cold reset.
Covers storing up to 10 users with passwords, editing, and deleting users.
Illustrates how to connect a transducer to the TorqueStar Opta via the 25-way D connector.
Details changing parameters like Units, Direction, Cycle End Time, and Frequency Response.
Details selecting fault causes and choosing actions for specific readings.
Details changing parameters like Units, Direction, Cycle End Time, and Frequency Response.
Details setting Torque Threshold, USL, Target, LSL, and Second Parameter settings.
Introduces jobs, subgroups, samples, and how to access the Jobs mode.
Covers fault selection, analysis actions, and the autostore option.
Lists and describes parameters configurable within the Jobs mode setup.
Details setting torque thresholds, upper/lower specification limits, and target values.
Defines rounds as groups of jobs and explains how to access the Rounds mode.
Guides on how to alter transducer type, span, units, pulses, millivolts, and bridge resistance.
Covers initial setup, recommended readers, and connecting the reader to the Opta.
Details connecting the Opta to a PC for data transfer using Opta Comms software.
Explains the software activation code and the process to unlock features.
Guides on using arrow keys and numeric keys to enter the activation code.
Introduces the DTT Opta, highlighting features like interchangeable modules and printer.
Illustrates how to connect the transducer module to the DTT Opta.
