31
Crane Electronics Ltd
The force in torque management
Crane Electronics Ltd
Watling Drive
14 88
-electronics.com
Whilst in measuring mode with a selected transducer if you decide to
change the measurement mode then all reading results will be reset.
If you start pulling torque before you are in the measuring screen then you
will be warned that the ‘Zero Offset’ is over-ridden by a certain %.
First phase in retighten measure mode. Untighten in CCW direction.
Second phase in retighten measure mode. Retighten in CW direction until
specified audit angle is reached.
Unfasten torque has to be greater than 10% of attached transducer span.
Invalid unlock code. Check code HEX and re-enter. Make sure it is the
correct code for the device serial number.
If there is a problem with the internal SD card then traces will be disabled.
Over-torqued transducer.
Invalid mode, e.g. trying to use a force transducer for a torque
measurement.
To Next Page
Loading...
