Crane Electronics TorqueStar Plus - Rounds; Add Rounds & Setup

39
Crane Electronics Ltd
The force in torque management
Crane Electronics Ltd
Watling Drive
Sketchley Meadows
Hinckley LE10 3EY
Tel: +44(0) 1455 25
14 88
www.crane
-electronics.com
You can view the Rounds downloaded or created on the TorqueStar Pro.
You can move through the list (up to 4 rounds displayed) using the up and down arrow keys. Each item in the
list will show a round name and description, the round type, and the percentage of completion.
The round position in the list and the total number of rounds is displayed in the top middle of the display.
(F1) Add Rounds (Note. you cannot edit or delete rounds downloaded from OMS Lite)
You can move between rounds settings screens with (F4) and (F3) icons.
Screen 1:
Round Name = (appear on Round list screen)
Round Description
Directions:
Any order = Select any Job from the Round Job List using
Up and Down arrow keys.
Vertical = Start at the first Job in the Round Job List then
after completing a subgroup in the previous Job, start the
subgroup in the next job on the list.
Horizontal = Start at the first Job in vertical Job List then
perform 1 reading from each Job in the list, before
repeating the process.
Prompt = Prompt after finishing last job before starting
next
Note. You cannot add the same Job to more than one Round on the TorqueStar Pro. (It is possible that Rounds
downloaded from OMS Lite might contain the same Job).
ROUNDS