BevMax_Media_Programming_10_6_10 Page 98 of 106
08/15/2013
These charts are intended as a guide to isolate and correct most problems you might encounter. Should your
machine show ‘OUT OF SERVICE”, go in the TEST MODE and press “B” to list errors.
ALL COINS ARE REJECTED
All coins are rejected.
Main Power Off /
disconnected.
Blown I/O Board fuse.
Loose connection.
Apply power.
Check fuse, replace as
necessary.
Check harness at Coin
Mech and Atlas Board.
Jammed Coin Mech.. Clear coins.
Weak springs on
changer gate.
Replace spring.
Gate partially open. Clean & reset gate.
Dirty / faulty coin
sensor.
Clean / replace.
Incompatible Coin
Mech.
Replace.
Defective coin mech. Replace.
Defective Atlas board. Replace.
To Next Page
Loading...
