EasyManuals Logo

Crestron CP3N Reference Guide

Crestron CP3N
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
Reference Guide DOC. 7150B 3-Series Control Systems 31
Remote System Logging
Control system messages can be captured and stored on a remote server using
the remote system logging function.
NOTE: The remote server host must have system log server with the applicable
security certificates and sufficient disk space to store the active system log. The
host should also be configured to archive older system logs and to off load them
over time. If TLS is enabled, a TLS-enabled server with the appropriate
certificates is required.
To configure remote system logging, issue the REMOTESYSlog command.
Syntax: REMOTESYSlog [-S] {-E} {-A} [-I:address] [-P:port]
{-T:protocol} {-V:ON|OFF}
o -S:[ON|OFF]: Enables or disables remote system logging
o -E:[level]: Logs all messages at the provided error level and above.
The default setting is “Notice.”
OK
Info
Notice
Warning
Error
Fatal
o -A: Appends the contents of the audit log to the system log
NOTE: Audit logging must be turned on to use this feature. For more
information, refer to "Audit Logging" on page 32.
o -I:address: Sets the remote server IP address for the system log in
dot decimal notation or as an ASCII string containing the server host
name (maximum 255 characters)
o -P:port: The remote server port number in decimal notation
o -T:protocol: The protocol used to connect to the remote server
TCP
UDP
SSL
o -V: If SSL is enabled, set to ON to require server verification or set to
OFF to not require server verification.
o No parameter: Displays the current setting
Example: REMOTESYSlog -S:ON -E:NOTICE -A -I:255.255.255.255
-P:12345 -T:SSL -V:OFF
Remote system logging can also be configured in Crestron Toolbox using the
Syslog function. For more information, refer to the Crestron Toolbox help file.

Other manuals for Crestron CP3N

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Crestron CP3N and is the answer not in the manual?

Crestron CP3N Specifications

General IconGeneral
Internal memory0.5 GB
Storage media typeFlash
Internal memory typeSDRAM
Internal storage capacity4 GB
AC input voltage100-240 V
AC input frequency50 - 60 Hz
Power consumption (typical)24 W
Operating temperature (T-T)5 - 45 °C
Operating relative humidity (H-H)10 - 90 %
Product colorBlack
Heat dissipation50 BTU/h
Housing materialMetal
Ethernet LAN (RJ-45) ports2
Weight and Dimensions IconWeight and Dimensions
Depth167 mm
Width439 mm
Height44 mm
Weight1420 g

Related product manuals