Crestron CP3N Reference Guide

Reference Guide – DOC. 7150B 3-Series Control Systems • 43
Master-Slave Configuration
Use the following console commands to configure master-slave mode
parameters for the control system.
Add Master Entry
To add a master entry to the IP table, use the ADDMASTER command.
• Syntax: ADDMASTER [cipid] -[ip_address/name]
o cipid: The ID of the CIP node (in hexadecimal format)
o ip_address/name: The IP address (in dot decimal notation) or the
name of the site for DNS lookup
• Example: ADDMASTER 1E -PRO3-IH
Remove Master Entry
To remove a master entry from the IP table, use the REMMASTER command.
• Syntax: REMMASTER [cipid] -[ip_address/name]
o cipid: The ID of the CIP node (in hexadecimal format)
o ip_address/name: The IP address (in dot decimal notation) or the
name of the site for DNS lookup
• Example: REMMASTER 1E -PRO3-IH
View Master IP Table
To view the master IP table, use the MIPTABLE command. Append [-T] to the
command to output the results in table format.
View Slave Status
To display the status of the slave processor, use the SLAVESTATUS command.

Crestron CP3N Specifications

General

Internal memory	0.5 GB
Storage media type	Flash
Internal memory type	SDRAM
Internal storage capacity	4 GB
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Power consumption (typical)	24 W
Operating temperature (T-T)	5 - 45 °C
Operating relative humidity (H-H)	10 - 90 %
Product color	Black
Heat dissipation	50 BTU/h
Housing material	Metal
Ethernet LAN (RJ-45) ports	2

Weight and Dimensions

Depth	167 mm
Width	439 mm
Height	44 mm
Weight	1420 g