17
The CS5355 Wired LAN(IP) Card (continued)
To install:
1. Follow steps 1, 2 and 3 on the next page.
2. Using a Cat5 lead fitted with RJ45 connectors, connect the metal boxed
socket on the Wired LAN Card to a LAN connection point. See Fig 6.
3. Re-connect the power supply. The CS5355 Wired LAN Card may be used
with alarm systems power supplies between 12 and 30 volts.
4. Using the A & B buttons, enable the Wired LAN Card. See Appendix 1,
Tables 30 & 31.
Operation:
On the metal boxed socket, where the LAN cable connects are Yellow and
Green LEDs. When properly connected:
a). the Yellow LED will be on solidly indicating that the LAN cable has a
connection at its other end.
b). the Green LED will blink on once every 1-2 seconds indicating data to/
from the LAN(IP) Card.
Where communication errors are present these will be shown as ‘E’ numbers
on the DualCom’s display. See table 36, E41 to E49 in Appendix 1.
LAN communication status and call progress is shown on the Green LAN LED.
See table 20 and 21 in Appendix 1.
Note:
The CS5355 LAN(IP) Card may be used with alarm systems where the power
supply is between 12 and 30 volts.
The older CS2355 LAN(IP) Card must not be used with supply voltages above
15 volts.
To Next Page
Loading...
Need help?
General
