CSL GradeShift User Manual

42
NVM Programming
DualCom GPRS is supplied with its NVM already programmed for communica-
tion with the designated ARC and fitted to its socket. This NVM should not be
removed from its socket.
NVMs from other types of DualCom will not work in DualCom GPRS.
The CS0054 Programmer for DualCom is available from CSL. This will read the
DualCom’s operational parameters and the diagnostic information, e.g. received
signal strength.
Contact CSL Technical Support for further information.
SMS (Short Message Service) Sending
On the current DualCom GPRS, there is reduced facility to send SMS (text)
messages to mobile phones.
Contact CSL Technical Support for further information.
SMS Remote Control
When the Aux Output is selected for SMS Remote Control (See Fault & Aux
Outputs section) then the Aux Output relay may be switched on or off by send-
ing an SMS (text) message to the DualCom from a mobile phone.
This may be used to remotely control any other item, e.g. lighting, gates.
Contact CSL Technical Support for further information.
Power Supply or
Control Panel DualCom
Fig 27
+
0 v
+9-30v
System Power Supply and Battery (continued)

CSL GradeShift Specifications

General

Brand	CSL
Model	GradeShift
Category	Security System
Language	English