APPENDIX 1
99 error detected at Power-up/Reset (continued)
If PSTN polling is enabled: there must be a PSTN polling number and a
PSTN account number.
If this fails PSTN Polling Service is disabled.
If ALL of the above fail, and if any Polling Service is ticked in the NVM, and...
if Polling was previously enabled, then an immediate E99 will occur.
If Polling was not enabled, a E99 will occur after 45 minutes.
After the normal sounder beeps have timed out, when E99 is present, the
sounder will beep once every 5 minutes.
NOTE: Although paths will be disabled independently depending on the
parameter programming as shown above, the E99 error will only occur if ALL
paths have thus been disabled.
None of the above will affect SMS or the ability of the DualCom to accept
incoming Programming calls, or make outgoing Download server calls upon
request (assuming that this part of NVM programming is correct!).
60
To Next Page
Loading...
Need help?
General
