OPERATION MICRO-TEMP
®
LT, Model 749
OPERATION AND TECHNICAL MANUAL
Page 28 of 75
1. The set temperature on the status display changes.
G. When the desired set temperature is displayed, release the Up or Down arrow and the
“SET” button.
NOTE: If water temperature is >1°C (2˚F) over the set point temperature, the display will
flash and the unit will sound an audible indicator
H. Check that the water is circulating.
I. Touch the localized heat therapy pad to confirm that the pad is heating.
J. Allow fifteen to twenty minutes for the water to reach selected temperature.
K. To check the set point temperature, press the “SET” button.
L. To make any changes in the control settings, press and hold the “SET” button and begin
pressing either the “Up” or “Down” arrow to change the set point temperature.
The MICRO-TEMP
®
LT unit is now operating. Continue to monitor the unit and the patient.
If at any time the display shows a message other than the water or set point temperature, consult
the list of display and indicator messages in Section (3-5). If at any time the unit sounds an audible
indicator, make the changes indicated and/or consult the list of indicator messages in Section (3-5).
To turn off the unit or discontinue localized heat therapy treatment, proceed as described in Section
(3-4).
3-4. CONCLUDING LOCALIZED HEAT THERAPY TREATMENT
To stop the unit, the operator must turn the power switch to the “O” (OFF) position.
When the localized therapy is concluded and the unit is turned OFF:
A. Disconnect the power cord from the power source and loosely coil it together,
securing with the attached velcro strap.
B. Remove the pad.
C. For Single-Patient Use TEMP-PAD
®
, MAXI-THERM
®
and MAXI-THERM
®
LITE pads
follow the instructions packaged with the pad.
D. Wrap hose around the bottom recessed area of unit.
To Next Page
Loading...
