CTC Union SHDTU03-ET10R - Determine Connection Setting

Chapter 2. Configuration
2-2
Step 4: Determine Connection Setting
Users need to know the Internet Protocol supplied by your Service Provider
and determine the mode of setting.
Protocol Selection
RFC1483 Bridged Ethernet over ATM
RFC1577 Classic Internet Protocol over ATM
RFC2364 Point-to-Point Protocol over ATM
RFC2516 Point-to-Point Protocol over Ethernet
The different Protocols need to setup different WAN parameters. Once
knowing the Protocol provided by your ISP, you will need the following
necessary WAN parameters.
Bridge EoA Route EoA
VPI:
VCI:
Encapsulation:
IP Address:
Subnet Mask:
Gateway:
DNS Server:
Host Name:
(if applicable)
VPI:
VCI:
Encapsulation:
Gateway:
Host Name: (if applicable)