Chapter 8. Configuration Commands
8-9
Setup
All of the setup parameters are located in the subdirectories of setup. Move the cursor “ >> “ to
setup and press enter.
>>
mode Switch system operation mode
shdsl Configure SHDSL parameters
wan Configure WAN interface profile
bridge Configure transparent bridging
vlan Configure virtual LAN parameters
route Configure routing parameters
lan Configure LAN interface profile
ip_share Configure NAT/PAT parameters
firewall Configure Firewall parameters
dhcp Configure DHCP parameters
dns_proxy Configure DNS proxy parameters
hostname Configure local host name
default Restore factory defau lt setting
Mode
The SHDTU03 can act in either routing mode or bridging mode. The default setting is routing
mode. You can change the system operation mode by using the mode command. Move the
cursor “ >> “ to mode and press enter.
------------------ ----------------------------------------------------
Command: setup mode <Route|Bridge>
Message: Please input the following information.
System operation mode (TAB select) <Route>: Route
-------------------------------------------------------------------- --
To Next Page
Loading...
Need help?
General
