Chapter 8. Configuration Commands
8-1
To setup the router, move the cursor “ >>” to enable and press the enter key. When the
screen appears, type the supervisor password. The default supervisor password is root. The
password will be written on screen as “ * “ symbol for system security.
----------------------------------------------------------------------
Command: enable <CR>
Message: Please input the following information.
Supervisor password: ****
----------------------------------------------------------------------
In this sub menu, you can setup management features and upgrade software, backup the system
configuration and restore the system configuration via utility tools.
For system security, it is recommended to change the default user name and password after
completing these settings. After changing the User Name and Password, it is strongly recommend
you write the user name/password down and save it, since they will be required the next time you
login to the Router.
For any changes to the configuration, you must write the new configuration to Flash and reboot
the router to activate the new settings.
The screen will prompt as follow.
>>
enable Modify command privilege
setup Configure system
status Show running system status
show View system configuration
write Update flash configuration
reboot Reset and boot system
ping Packet internet groper comm and
admin Setup management features
utility TFTP upgrade utility
exit Quit system
To Next Page
Loading...
Need help?
General
