Chapter 8. Configuration Commands
8-3
Reboot
To reboot the router, use the reboot command. Move the cursor to “ >> “ to reboot and press
enter.
----------------------------------------- -----------------------------
Command: reboot <CR>
Message: Please input the following information.
Do you want to reboot? (y/n): y
----------------------------------------------------------------------
Ping
Ping command will be used to test the connection of the router. Move the cursor “ >> “ to ping
and press enter.
----------------------------------------------------------------------
Command: ping <ip> [1~65534| -t] [1~1999]
Message: Please input the following information.
IP address <IP> : 10.0.0.1
Number of ping request packets to send (TAB select): 1~65534
Data size [1~1999]: 32
----------------------------------------------------------------------
Administration
You can modify the user profile, telnet access, SNMP (Sample Network Management Protocol),
supervisor information and SNTP (Simple Network Time Protocol) in admin. The route is enable
? admin.
For configuration of the parameters, move the cursor “ >> “ to admin and press enter.
>>
user Manage user profile
security Setup system secu rity
snmp Configure SNMP parameter
passwd Change supervisor password
Id Change supervisor ID
sntp Configure time synchronization
To Next Page
Loading...
